Us Made Ford 2n 9n 8n Spin On Oil

This listing is for a spin on oil filter adapter for the Ford 9N 2N 8N tractors PLUS A NEW PAIR OF BRASS TUBING CONNECTORS.  This assembly includes a pair of #87971S, Connector, Thread, Tube To Oil Filter 1/8" X 7/16"-24 (For reference only).  This assembly is a direct bolt on replacement for the messy original equipment canister filter.  THE OIL FILTER IS NOT INCLUDED.  The key attributes of this adapter are:  

1. Filter is orientated in the vertical direction.  Unlike the original filter or horizontal adapters, the oil is kept within the filter during filter changes for a virtually zero mess filter change.
2. By orientating the filter vertically, the user can easily "prime" the oil filter by filling with oil prior to installation.  Once an engine is started an empty filter will rob oil pressure from the rest of the engine until it is full.  This filter adapter addresses that issue.
3. A vertically orientated filter will remain full once the engine is shut off.  Upon restart, the filter does not need to refill allowing the engine to build full oil pressure faster thus helping to reduce engine wear that occurs during start up.
4. The sealing surface between the filter and adapter has been face milled in a single pass to ensure a flat and smooth sealing surface to prevent leaks and seeps.  Extruded aluminum can vary in flatness and often has scrapes and scuffs on the surface.  Ensure that the filter adapter you buy has been face milled for the highest level of sealing integrity.
5. The adapter has a 1/16" (.062") diameter orifice built in to prevent the filter from robbing more than it's fair share of oil from the rest of the system and maintaining lube system balance.  This is the same size orifice used on the original Ford filter housing.
6. The oil enters on the right side (facing the engine) and exits out the left side like the original.  The oil flow through the spin on filter is from the outside of the pleats to the inside of the pleats. 
7. The ports are threaded with 1/8" NPT threads which will allow you use the original Ford fittings.
8. Made in USA out of American made Kaiser 6061-T6 aluminum.
9. Pays for itself with the savings associated with using more commonly available spin on filters.
10. The threaded steel spud is threaded with 3/4-16 threads.  This allows you to use the following filters (and this is just a short list):

• Fram:  PH16, PH7, PH43
• AC Delco:  PF56, PF13, PF20, PF34
• Fleetguard:  LF785, LF655, LF580, LF689
• Baldwin: B34, B74, B163, B233
• John Deere:  TY9427, TY22047, TY15592
• Motorcraft:  FL300, FL787
• Napa:  1084

SHIPPING 

We do our best to ship within 24 hours of receiving your order.  Depending on where you live, we will use the Post Office, SPEE-DEE or UPS to get your shipment to you as quickly as possible.

If you order multiple items, please do not pay for them until I can invoice you with the correct shipping charges.

We do offer free pickup of your parts at our farm in Verona, WI.

If you have a special request for shipping, please contact us.